Virtual Dj Le Ddj Ergo V Windows 8.1 And 10

Virtual Dj Le Ddj Ergo V Windows 8.1 And 10

My setup works fine absolutely fine with VDJ 7 when using ASIO any ideas where I may be going wrong with VDJ 8.1 Have had problem with Windows 8.1 and 10.

Can you post the Audio configuration of 8.0 and 8.1 separately Do both ver 8.0 and 8.1 offer identical audio configuration Did you try to re-install Pioneer ASIO drivers.

Do you want to use it.

Clicked Use Soundcard) Failed Scenario: DDJ-ERGO Config: (appears to be the one recommended in the manual), and would seem to match my VDJ 7 setup.

OUTPUT: SPEAKER HEADPHONE CARD: PIONEER DDJ-ERGO INPUT: MICROPHONE Source Sound Card Channel Bit Rate Master Pioneer DDJ ASIO (ASIO) DDJ-ERGO MASTER LR 44100 Hz Int32LSB 4 cha Headphones Pioneer DDJ ASIO (ASIO) DDJ-ERGO PHONES LR 44100 Hz Int32LSB 4 cha Mic Pioneer DDJ ASIO (ASIO) DDJ-ERGO AUXMIC LR 44100 Hz Int32LSB 4 cha Working Scenario OUTPUT: SPEAKER HEADPHONE CARD: PIONEER DDJ-ERGO INPUT: MICROPHONE Source Sound Card Channel Bit Rate Master Pioneer DDJ-ERGO (WASAPI) Chan 12 44100 Hz Int32LSB 4 cha Headphones Pioneer DDJ ERGO (WASAPI) Chan 34 44100 Hz Int32LSB 4 cha Mic Pioneer DDJ ASIO (ASIO) DDJ-ERGO AUXMIC LR Not connected Failed to ini Hope this makes the screenshot clearer Many thanks Rich.

I would re-install the ASIO drivers (uninstall, restart computer, install again), just to make sure.

In case you are not using the Microphone Input, try to delete the Microphone line from the Audio setup and see if that helps.

If I start VDJ 7.0 ASIO works fine - so I dont understand why the default config is not working in 8.

Bear in mind Ive seen the same configuration problem with 8 with Windows 8.1 and 10, and 8.1 with Windows 10.

I think Ive gone through many installations already.

Beginning to think the actual ERGO HW is broken, although it lights up (especially after the firmware update) but fails to connect.

I have also tried 2 x similar cables in case that was at fault.

Virtual Dj Le Crack Ddj Ergo V